LG Washer Repair
in Eltingville.

The OE error means your LG washer cannot drain water fast enough. It's the most common call we get from Eltingville and Annadale. In most cases it's a clogged filter or a failed pump motor — both are same-day fixes.

What causes OE:

• 1Clogged drain pump filter — lint, coins, hair ties, small items
• 2Kinked or blocked drain hose behind the machine
• 3Failed drain pump motor (Part #4681EA2001T) — needs replacement
• 4Faulty pressure switch or control board — less common

Try this first:

• 1Find the small access panel at the bottom front of the washer
• 2Lay towels down and place a shallow pan — water will come out
• 3Slowly unscrew the filter cap and let it drain completely
• 4Pull the filter out and rinse it clean under running water
• 5Check the drain hose at the back — no sharp kinks
• 6Reinstall and run a rinse cycle

The LE error means the direct-drive motor has detected a fault or overheated. The machine stops to protect itself. We handle LE repairs across Staten Island regularly — same-day in most cases.

What causes LE:

• 1Overloaded drum — too much laundry at once, motor works too hard
• 2Motor overheated — needs 30 minutes to cool before restarting
• 3Worn hall sensor — sends incorrect speed signal to the control board
• 4Stator winding fault — motor disassembly required for diagnosis
• 5Wiring harness issue between motor and control board

Try this first:

• 1Unplug the washer and wait 30 minutes — let the motor cool fully
• 2Remove about half the laundry from the drum
• 3Plug back in and try a short spin-only cycle
• 4If LE returns immediately — the motor needs professional diagnosis

The UE error means the drum detected an unbalanced load and stopped to protect itself. You can often fix it yourself in two minutes.

Fix it yourself:

• 1Open the door and redistribute wet laundry evenly around the drum
• 2Never wash one heavy item alone — add smaller pieces for balance
• 3Check the machine sits level — adjust the feet if it rocks
• 4Close and resume the cycle

If UE keeps returning with a balanced load:

• 1Worn shock absorbers or suspension rods — drum can't self-stabilize at high RPM
• 2Control board calibration fault — requires on-site diagnosis

The dE error means the washer can't confirm the door is locked. It won't run without a confirmed lock — safety by design. Usually a quick fix.

• 1Check for clothing caught in the door seal or around the latch
• 2Push the door firmly — you should feel and hear a definite click
• 3Inspect the latch and strike plate for visible cracks
• 4Unplug the machine for 60 seconds and try again

The IE error means the washer isn't filling with water fast enough. Check the basics before calling.

• 1Both hot and cold shutoff valves behind the machine must be fully open
• 2Check that inlet hoses aren't kinked at the back
• 3Unscrew the hose connections and clean the mesh screen filters inside
• 4Low water pressure in the home can also trigger IE